Setup Guide — TP Receivers
This card provides instructions for an experienced
installer to set up and operate the TP Receiver Series
products.
Refer to www.extron.com for the complete user’s
manual.
Pre-installation — Jumper settings
The TP R BNC A and TP R BNC AV are factory configured to receive
RGB video. They can receive component, S-video or composite video
by changing jumper J3 located on the main board.
RGB
J3
J3
3
2
1
If using the TP R BNC AV with an older TPX 88X transmitter,
download the TP Receivers User’s Manual at www.extron.com
and refer to the audio jumper settings.
N
3
2
1
Component,
S-video,
Composite
Installation
Step 1 — Mounting
Turn off or disconnect all equipment power sources
and mount the receiver as required.
RJ-45 Connector
T568A
Pin Wire color
T568B
Side
Pins:
Wire color
White-green White-orange
Green Orange
White-orange White-green
12345678
1
2
3
4
5
Step 2 — Connect input
Connect the RJ-45 cable (from a TP transmitter)
to the Input port on the TP R.
Blue
Blue
White-blue
Orange
White-blue
Green
Terminate the ends of the cable to the same
standards.
6
7
8
White-brown White-brown
Brown Brown
Insert
Twisted Pair
Wires
NOTE If using Enhanced
Step 3 — Connect outputs
Attach the applicable output cables (video, audio),
depending on the TP R model.
Skew-Free™ A/V cable, use the
TIA/EIA T568A standard only.
a. Composite video output connector — Connect to the single female BNC
connector (VIDEO) for composite video output (TP R BNC AV Only) or to
either the R, or G, or B connectors (TP R BNC A Only).
b. S-video output connector — Connect to the R (C-chroma) and G (Y-luma)
connectors.
c. Component video — Connect to the R (R-Y), G (Y) and B (B-Y) connectors.
d. RGBHV Video — Connect to the R, G, B, H, V connectors.
e. RGBS video — Connect to the R, G, B, H/V connectors.
f. High resolution video output connector — Connect to the 15-pin HD
connector (TP R 15HD A only).
g. Audio connector — Connect an audio device accepting line level analog
audio to the unbalanced stereo audio RCA connectors (TP R BNC A and
TP R BNC AV) or to the line level stereo 3.5 mm, 5-pole captive screw
connectors as shown.
Do not tin the wires!
Tip
NO GROUND HERE
Sleeves
Tip
Ring
Sleeves
Tip
Ring
Tip
NO GROUND HERE
Unbalanced Output
Balanced Output
C
For unbalanced audio, connect both sleeves to the center (ground)
contact. DO NOT connect the sleeves to the negative (-) contacts.
Continued on other side
|
Euro Pro Iron GI468C User Manual
Exmark Lawn Mower VH3615KA User Manual
Extron electronic Telephone XTP SR HDMI User Manual
Fender Guitar 193560 User Manual
Fisher Price Baby Carrier M1351 User Manual
Fisher Price Cordless Sander H0779 User Manual
Furman Sound Stereo Amplifier MS2A 1 User Manual
Furuno Marine RADAR FAR FR 2815 2825 User Manual
Generac Power Systems Automobile Parts SD150 User Manual
GE Washer WZRE5260 User Manual