Adams Electric Heater Low Intensity Infra Red Heater User Manual

Sun-Heat Standard System Features

GAS BURNER

• Burner and controls CSA listed for United States and Canada

• Hot Surface ignition and electronic safety–No Pilot

• 60,000, 80,000, 100,000, 125,000, 150,000, 175,000,

200,000 Btu/hr input sizes (natural or propane gas)

• Combustion Air inlet collar

• Sight glass for monitoring burner operation

• Combustion air proving differential switch

• Electrical & gas controls separated from combustion

air stream

• Burner Housing 18 GA. galvanized steel

• Electrical –120 volt/60/1 ph

• CSA listed for Vented or Unvented applications

( )

• 1 year limited warranty

TUBE SYSTEM

• Combustion chamber–10' x 4" OD, 16 gauge aluminized

steel with flared burner mounting flange

• Heat exchanger– as required, remaining system comes

in 10' or 5' 16 gauge aluminized steel

• Flared fitting pipe connector with draw bolts at each joint

for solid compression type fitting–no gaskets or draw bands

• 20' to 70' systems–Straight systems or optional “L” or “U”

shaped systems using 90 deg elbows. (see schedule for

tube lengths available)

FLARED PIPE FORMS

• 10 year limited warranty

Male-Female Type Connection

Compression Fitting

No Clamps or Draw Bands

REFLECTORS

• High polished parabolic reflectors standard

• 8' or 4' lengths

• Reflector shield and tube system supported by heavy gauge

wire hangers placed approx. 7' apart

OPTIONAL FEATURES

• Outside combustion air inlet hood with flexible 4" diameter duct

• 90 deg elbows for “L” or “U” shaped configurations

• Diffuser “V” reflector for low mounting applications

• Vent cap adapter (4" dia steel to 4" dia class “B” vent pipe

• Line voltage thermostat

• 24 volt relay to convert line voltage thermostat to

24 volt thermostat

• Burner “ON” running light